Skip to product information
1 of 4

The Native Farm

50mm Poly Pipe Compression Equal Tee Metric Blue Line Irrigation 50x50x50

50mm Poly Pipe Compression Equal Tee Metric Blue Line Irrigation 50x50x50

Regular price $24.00 AUD
Regular price Sale price $24.00 AUD
Sale Sold out
Taxes included. Shipping calculated at checkout.
Pack

50mm Equal Tee Compression Fitting for Metric Poly Pipe

50mm polypropylene equal tee. Takes a branch off a run of 50mm metric poly pipe — all three ends the same size. No glue, no solvent, no special tools, and it comes apart again if you need to move the line.

Buying the 8-pack saves you $63 and ships free.
It goes as one parcel.

What it fits — and what it doesn't

  • Fits 50mm metric poly pipe — 50.0mm outside diameter. This is blue line pipe to AS/NZS 4130, and the same 50mm size in HDPE, MDPE and LDPE.
  • Does not fit rural poly. Australian 2" rural pipe is about 57mm outside diameter and needs rural fittings. The nut opening on this tee is 53mm, so 2" rural pipe will not pass through it.
  • Does not fit PVC pressure pipe. Australian DN50 PVC is 60.3mm outside diameter.
  • Not sure which you have? Measure the outside of your pipe with a tape. It needs to be 50mm.

Not WaterMark certified. Not for use in regulated plumbing or drinking-water supply. Intended for irrigation, stock water, ponds and other non-potable outdoor use.

Typical jobs

Splitting a mainline to two paddocks or two tank outlets, branching a pump delivery line, and row take-offs on an orchard mainline. Reduce down after the tee with a 50mm-to-smaller compression reducer from your irrigation store.

Specifications

Size 50mm x 50mm x 50mm metric — fits 50.0mm OD pipe
Pressure rating PN16 — manufacturer's published figure
Body material Polypropylene copolymer
Seal D-ring with grip ring and compression nut, all three ends
Length 275mm across the run
Height 180mm to the branch
Nut outside diameter 71mm
Nut opening 53mm
Weight 655g each
Colour Blue nuts, black body
Nut branding Compression nuts moulded "Bentlay's 50mm"

Fitting it

Cut the pipe square. Loosen the nut, push the pipe in until it seats past the D-ring, then hand-tighten the nut. The grip ring closes onto the pipe as the nut goes on. To take it apart, back the nut off — the grip ring comes free on the pipe and the D-ring lifts out for cleaning. Works on wet pipe and in the trench.

Also in the range

50mm coupler, 90° elbow and end cap in the same metric size, and a repair kit with two couplers and a length of pipe. Search the shop for "50mm metric".

Where these came from

Excess stock from our own farm irrigation project near Bendigo in central Victoria. We bought pipe and fittings in bulk for the orchard and over-ordered on the fittings. Ships from Bendigo.

View full details